• Bichromatic optics. Six filters standard.
• Easy to use with step-by-step prompting and on-board graphics printer.
• 12 station 37°C incubation block and temperature controlled read well. Cuvette size is 12mm by 75mm.
• Performs both endpoint and kinetic assays.
• Large non-volatile memory stores approximately 60 user programs.
• With Mosquito™ flowcell accessory you can read volumes as small as 250 microliters.
• CE certified.
• Stat Fax® readers use IAD filters.
Stat Fax®1904
Linear Measurement Range
-0.20 to 2.50 Absorbance Units (A)
Photometric Accuracy
+/- (1% of the reading + 0.005 A)
Stability
Drift of no more than 0.005A in 8 hours/bichromatic
Light Source
Tungsten halogen lamp, with lamp saver feature
Standard Wavelengths
340、405、450、505、545、630
Type of Filter
IAD hardcoat interference, 10nm half bandpass
Tube Size
12 mm round is standard
Display
Alpha numeric, 16 character LCD
Printer
Thermal dot matrix, 20 characters per line, plus graphics
Keyboard
16-key, domed membrane switch, enunciating
Power Requirements
115V or 230V AC, 50-60 Hz (switch selectable)
Microprocessor
Z180
Speed
Reads, calculates and prints results in 3 seconds/tube
Calculation Modes
Single point calibration by standard or factor, multipoint calibration with point-to-point curve fit, rate by standard or factor (batch or singly)
Test Menu
More than 50 open channels to store tests. Stores all parameters including wavelengths, calculations, unit codes, linear and normal ranges, rate timing, standard values, test names, and previous standard curve.
Temperature
37℃, block stays on, cell has on/off switch
Enclosure
Painted flame retardant ABS plastic cover with metal base.
Dimensions
Approximately 9 x 13.5 x 5 in. (24 x 34 x 13 cm) 10 lbs. (4.5 kg)
Certifications
NRTL listed, CE Mark
Awareness Technology is an ISO 13485:2003 Certified Manufacturer
High quality at low cost is not a new concept at Awareness Technology. For over 25 years, our service mark has been Cost-Effective by Design®, with no compromises in performance or reliability.
Manufacturing Facilities
30,000 sq. ft. (2800m2) Custom Designed Manufacturing Facility (completed March 2002) with：
• Complete metal working machine shop.
• Mechanical and Electrical Assembly.
• Incoming, In-Process, and Final Device Inspection.
• Laboratory.
• Expediting Services.
• 15,000 sq. ft. (1400m2) Manufacturing Facility
• 4,000 sq. ft. (370m2)Paint and Finishing Shop
